Vinyl ester resin, the liner tube and the inversion drum laid out on the drive before a lining run
All eight services

What we handle

A new pipe inside the old one.

Where the run allows it, the line is relined rather than dug up: a resin liner cured in place, so the drive, the slab and the mature planting over the top all stay where they are.

Call or text (213) 682-4466

Answered 24 hours, every day.

Two pails of Perma-Liner vinyl ester resin beside the liner tube and the inversion drum, set out before a lining run
Our own resin, liner and drum, before a run. There is no stock photography anywhere on this site.

The work behind the photograph.

Trenchless is not a way of avoiding the truth about a pipe, it is a way of avoiding the trench. The line is cleaned back to bare wall first, usually jetted and sometimes cut, then a resin-saturated liner is pulled or inverted into place and cured hard against the inside of the host pipe. What you end up with is a jointless pipe inside the old one, and joints are where roots and infiltration get in.

It suits a long straight run under something expensive to open: a concrete drive, a finished slab, a mature garden, a car park, the floor of a trading restaurant. It is quicker than an open dig on those runs and it leaves the surface untouched, which on some properties is most of the cost of the job.

It is not always the answer, and you will be told when it is not. A pipe that has collapsed, that has separated at a joint, or that has a serious belly cannot be lined: a liner follows the shape it is cured against, so a low spot stays a low spot and a break with soil washing into it needs to be dug. That decision is made off the camera run, in front of you, before anyone quotes either method.

Trained on the process, and certified on it.

Lining is not a process to learn on somebody’s house. Waterline Renewal Technologies, the group behind the Perma-Liner resin in the photograph above, trained and certified Ricky on the CIPP and AIPPR processes in February 2025, against ASTM F1216, ASTM F1743 and IAPMO IGC 351-18a, with the City of LA Greenbook alongside it. He earned it at J R Rooter & Plumbing Inc, where he worked before this company existed, and it runs to February 2027. The certificate carries his name rather than a company’s, which is the point of it: the training came here with him.

Leaves in place

Drives, slabs, planting

The reason to line rather than dig is the surface over the top of the run.

Result

A jointless pipe

Cured against the host wall. No joints is no easy way in for roots.

Prep

Cleaned to bare wall first

A liner is only as true as the pipe it is cured inside.

Not for

Collapses and bellies

A liner follows the shape it finds. Said before the quote, not after.

Book a visit

Get somebody out to the line.

Which fixtures are affected and roughly how long it has been going on is enough to start with. If it is backing up right now, the phone is faster than the form, and it is answered at any hour.

Used only to call you back about the work.

Usually wanted at the same time.

An opened trench in a concrete floor with the failed drain line exposed and tools laid around it

Sewer Mainline

Broken, bellied and offset line dug out and replaced, from the fixture to the city connection.

A camera reel, a locating wand and the inspection monitor set out on the ground behind the van

Camera Inspection

A camera down the line before anyone quotes a repair, so you are looking at the pipe and not an opinion.

The company’s own wheeled hydro jetter loaded in the van, hose reel above the pump and the pressure gauge on its plate

Hydro Jetting

Water at pressure, scouring the pipe wall back to bare instead of punching a hole through the grease.

Call nowBook a visit